Input Shaft Seal: Installation

WARNING: This page is about a different variant/trim than selected.

1.
- 1.
  
  NOTE: Use adhesive tape to cover the input shaft splines to prevent damage to the input shaft seal.
  
  Apply tape to the splines to protect the seal. Use the General Equipment: Adhesive Tape
- 2.
  
  NOTE: Make sure that a new component is installed.
  
  Position a new seal on the input shaft in the clutch housing.
- 3.
  
  Using the special tool, install the seal. Use Special Service Tool: 308-847 Installer, Inputshaft Seal.
- 4.
  
  Remove and discard the tape.

GFD140741

Courtesy of FORD MOTOR COMPANY

2.

Install the clutch slave cylinder and tighten the bolts.
Torque: 89 lb.in (10 Nm)

GFD140501

Courtesy of FORD MOTOR COMPANY

3.

Install the transmission. Refer to: Transmission .