Front Upper Arm: Installation
- 1.NOTE: Tighten the suspension bushing fasteners with the suspension loaded or with the weight of the vehicle resting on the wheels and tires, otherwise incorrect clamp load and bushing damage may occur.NOTE: Finger tight at this stage.
Position the upper arm and install the 2 new upper arm-to-frame bolts and nuts.
- 2.
Install the shock absorber and spring assembly. Refer to Shock Absorber and Spring Assembly .
- 3.
Use a suitable jack to raise the suspension until the distance between the center of the hub and the lip of the fender is equal to the measurement taken during removal (curb height).