Differential Carrier: Removal
WARNING: This page is about a different variant/trim than selected.
- 1.
Remove the axle assembly. Refer to Axle Assembly .
- 5.NOTE: The fixture mounting bolts must have the minimum specified thread engagement in the carrier or damage to the component may occur.
Install the Transmission Holding Fixture.
- 6.NOTE: The housing spreader adapter bolts must have the minimum specified thread engagement in the carrier or damage to the component may occur.
Install the Differential Housing Spreader Plate and Adapter for Differential Housing Spreader.
- 8.
Install the Dial Indicator Gauge with Holding Fixture and Clutch Housing Gauge.- Position the adapter tip in the spreader adapter hole.
- 9.NOTE: Overspreading may damage the component.
Spread the axle housing to the specification.
- 1.
Adjust the Dial Indicator Gauge to zero.
- 2.
Tighten the housing spreader screw to spread the axle housing to the specification.
- 3.
Remove the Dial Indicator Gauge with Holding Fixture.
- 1.
- 10.NOTE: Mark the differential bearing caps Top or Bottom and LH or RH appropriately before removing them. Always install the differential bearing caps in their original positions or damage to the component may occur.
Mark and remove the 2 differential bearing caps.
- 1.
Remove the 4 differential bearing cap bolts.
- 2.
Remove the 2 differential bearing caps.
- 1.
- 11.NOTE: Use wood blocks to avoid axle housing damage.NOTE: Index-mark the position of the differential bearing shims. The differential bearing shims must be installed in their original locations and positions.
Remove the differential carrier from the axle housing.
- 1.
Position the wood blocks.
- 2.
Position and push down on the 2 pry bars.
- 3.
Remove the differential carrier.
- 4.
Remove the Differential Carrier Spreader.
- 1.