Axle Carrier Bushing: Removal
WARNING: This page is about a different variant/trim than selected.
All bushings
- 1.NOTE: It is not necessary to remove the axle assembly from the jack.
Remove the axle assembly. For additional information, refer to Axle Assembly .
- 2.
Measure and record the width of the gap between the bushing front lip and the housing. Mark the housing at the point where the measurement was taken.
Axle tube bushing
- 3.
Position the Front Axle Mounting Bushing Cup Remover, Front Differential Housing Bushing Remover/Installer and Front Axle Mounting Bushing Drawbolt Installer as shown. Turn in the drawbar to remove the bushing.
Rear housing bushing
- 4.
Position the Front Differential Housing Bushing Remover, Front Axle Mounting Bushing Cup Remover, Front Differential Housing Bushing Remover/Installer and Front Axle Mounting Bushing Drawbolt Installer as shown. Turn in the drawbar to remove the bushing.
Front housing bushing
- 5.
Remove the pinion flange. For additional information, refer to Drive Pinion Flange and Seal .
- 6.
Position the Front Axle Mounting Bushing Cup Remover, Front Differential Housing Bushing Remover/Installer and Front Axle Mounting Bushing Drawbolt Installer as shown. Turn in the drawbar to remove the bushing.
All bushings