Stub Shaft Pilot Bearing and Seal: Removal

WARNING: This page is about a different variant/trim than selected.

NOTE: Install a new stub shaft seal whenever a halfshaft is removed.

1.

Remove the halfshafts. For additional information, refer to Front Drive Halfshafts .

2.

Using the Transmission Fluid Pump Remover and Slide Hammer, remove the intermediate shaft.

Courtesy of FORD MOTOR COMPANY

Courtesy of FORD MOTOR COMPANY

4.

Using a suitable seal remover, remove and discard the stub shaft pilot bearing oil seal.

5.

Using the Bearing Cup Remover and Slide Hammer, remove and discard the stub shaft pilot bearing.

Courtesy of FORD MOTOR COMPANY