Pinpoint Test A : The Adjustable Pedals Only Move In 1 Second Intervals: Notes
Refer to Adjustable Pedals , for schematic and connector information.
Normal Operation and Fault Conditions
The SCCM uses a Hall-effect sensor integral to the motor to identify the current pedal position. The SCCM sends a reference voltage along the sensor feed circuit, through the Hall-effect sensor and back to the SCCM along the signal return circuit.
When one or more of the following DTCs set, the adjustable pedals enter a "jog mode". The memory system recall does not function from either the memory set switch, IKT or the IA key while the pedals are in jog mode. The motor moves the pedals for only one second regardless of the length of time the adjustable pedals control switch is actually pressed.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B1368:11 | Adjustable Pedal Position Feedback Sensor: Circuit Short to Ground | Sets when the SCCM detects a short to ground on the Hall-effect sensor feed or return circuits. The SCCM continually checks for faults during normal operation when the ignition is ON and during the on-demand self test. |
| B1368:12 | Adjustable Pedal Position Feedback Sensor: Circuit Short to Battery | Sets when the SCCM detects a short to voltage on the Hall-effect sensor feed or return circuits. The SCCM continually checks for faults during normal operation when the ignition is ON and during the on-demand self test. |
Possible Causes
- Wiring, terminals or connectors
- Adjustable pedal motor
- SCCM
- Incorrect SCCM configuration