LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2017 >> Expedition XL, RWD >> Repair and Diagnosis >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Sunroof - Roof Opening Panel >> General Procedures >> Roof Opening Panel Alignment

Roof Opening Panel Alignment

NOTE: The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the roof opening panel motor has been removed from the roof opening panel assembly, a new roof opening panel motor has been installed or when a new roof opening panel assembly has been installed. For additional information, refer to Roof Opening Panel Motor Initialization .

  1. 1.

    Position the roof opening panel in the CLOSED position.

  1. 2.

    Loosen the 4 roof opening panel glass screws.

  1. 3.

    NOTE: Make sure the roof opening panel is centered in the roof opening.

    Adjust the roof opening panel glass height to specification.

GFD137898Courtesy of FORD MOTOR COMPANY

  1. 4.

    Maintain horizontal and vertical roof opening panel position while adjusting and tighten the 4 roof opening panel glass screws to 4 Nm (35 lb-in).

  1. 5.

    Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization .
scientia non olet · About LEMON Manuals