Crankshaft Front Seal: Removal

1.

NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan may cause engine failure.

Remove the A/C compressor belt. Refer to: Accessory Drive .

2.

Remove the crankshaft bolt and washer.
- Discard the bolt.

GFD135043

Courtesy of FORD MOTOR COMPANY

3.

Using a three leg puller, remove the crankshaft pulley.

GFD135044

Courtesy of FORD MOTOR COMPANY

4.

Using the Oil Seal Remover, remove and discard the crankshaft front seal.

GFD135045

Courtesy of FORD MOTOR COMPANY