Instrument Panel Cluster (IPC): Removal

All vehicles 

1. 1.
   
   
   NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new module after installation.

   Using a diagnostic scan tool, begin the Programmable Module Installation (PMI) process for the Instrument Panel Cluster(IPC) following the on-screen instructions.

1. 2.
   
   Lower the steering column to the lowest position.

1. 3.
   
   Remove the 3 screws and the lower steering column cover.
   • Disconnect the electrical connector for the brake pedal switch (if equipped).

Navigator 

1. 4.
   
   Remove the 2 IPC finish panel screws.

1. 5.
   
   
   NOTE: The 2 tabs on the LH A/C register must be pressed to release the LH side of the A/C register from the instrument panel or damage to the IPC finish panel may occur.
   NOTE: The 2 tabs that retain the LH A/C register can be accessed from the backside of the instrument panel with the lower steering column cover removed.

   Press the 2 tabs on the outer edge of the LH A/C register while pulling the IPC finish panel out from the instrument panel.

Expedition 

1. 6.
   
   Remove the 2 screws and pull the IPC finish panel straight out to release the retainers.

All vehicles 

1. 7.
   
   Disconnect the dimmer switch electrical connector.

1. 8.
   
   If equipped, disconnect the ambient air temperature sensor electrical connector and air tube from the IPC finish panel and remove the finish panel.

1. 9.
   
   Remove the 4 screws and the IPC.
   • Disconnect the electrical connector.