Belt-Minder ® Deactivating/Activating: Deactivating/Activating

If the Belt-Minder ® is already disabled, driving the vehicle with a MyKey™ programmed key overrides the deactivation, however, when the vehicle is subsequently operated using an administrator key, the Belt-Minder ® once again reverts to the disabled state.

1. 1.
   
   Turn the ignition switch to the RUN position.

1. 2.
   
   Wait until the safety belt warning indicator turns off (approximately 1 minute).

1. 3.
   
   
   NOTE: Step 3 must be completed within 30 seconds after the safety belt warning indicator turns off or the procedure must be repeated.

   Buckle then unbuckle the safety belt 3 times, ending with the safety belt unbuckled.

1. 4.
   
   
   NOTE: After Step 3, the safety belt warning indicator lamp illuminates for 3 seconds.

   Within 10 seconds of the safety belt warning indicator turning on, buckle then unbuckle the safety belt.

   • This disables the Belt-Minder ® feature if it is currently enabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds.
   • This enables the Belt-Minder ® feature if it is currently disabled. As confirmation, the safety belt warning indicator flashes 4 times per second for 3 seconds followed by a second series of 4 flashes per second for 3 seconds.

1. 5.
   
   After confirmation, the deactivation/activation procedure is complete.