Parking Brake Shoe Adjustment
Special Tool(s)
| Brake Adjusting Gauge 206-D002 (D81L-1103-A) or equivalent |
- 1.NOTE: Make sure the parking brake is fully released.
Using the release handle, release the parking brake control.
- 2.
Remove the rear brake disc. For additional information, refer to Rear Disc Brake .
- 3.
Using the Brake Adjusting Gauge, measure the inside diameter of the drum portion of the rear brake disc and set the locking screw.- Record the measurement.
- 5.
Adjust the parking brake shoe clearance to 0.45 mm (0.02 in) less than the inside diameter of the drum portion of the rear brake disc.- Rotate the parking brake shoe adjuster to achieve the correct parking brake shoe-to-brake disc clearance.
- 6.
Install the rear brake disc. For additional information, refer to Rear Disc Brake .