Roof Opening Panel Weatherstrip: Removal

NOTE: The roof opening panel must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the roof opening panel has been removed from the roof opening panel assembly, a new roof opening panel motor/module has been installed or when a new roof opening panel assembly has been installed. For additional information, refer to Roof Opening Panel Motor Initialization .

1. 1.
   
   Remove the roof opening panel glass. For additional information, refer to Roof Opening Panel Glass .

1. 2.
   
   Place roof opening panel, topside up, on a worktable. Take care to support the glass assembly from below to prevent damaging the mounting tabs.

1. 3.
   
   Remove the old roof opening panel weatherstrip by pulling up on the weatherstrip.

Courtesy of FORD MOTOR COMPANY