LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2017 >> Expedition XL, RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Sunroof - Roof Opening Panel >> Removal And Installation >> Roof Opening Panel Motor >> Installation

Roof Opening Panel Motor: Installation

  1. 1.

    Connect the roof opening panel motor electrical connector.
GFD137905Courtesy of FORD MOTOR COMPANY

  1. 2.

    NOTE: When installing the roof opening panel motor/module, align the 3 attach holes before engaging the drive gear into the roof opening panel drive cable. Do not rotate the motor assembly after the drive gear is engaged with the roof opening panel drive cable. Otherwise, the cable can bind.

    Install the roof opening panel motor.

    • Align the attach holes, then install the 3 screws and tighten to 4 Nm (35 lb-in).
GFD137906Courtesy of FORD MOTOR COMPANY

  1. 3.

    Connect the overhead console electrical connectors.

  1. 4.

    Initialize the roof opening panel motor/module. For additional information, refer to Roof Opening Panel Motor Initialization .

  1. 5.

    Disconnect the overhead console electrical connectors.

  1. 6.

    Install the headliner. For additional information, refer to Interior Trim and Ornamentation .
scientia non olet · About LEMON Manuals