Inspection and Verification

1. 1.
   
   Verify the customer concern by operating the power exterior mirrors or memory mirrors.

1. 2.
   
   Visually inspect for obvious signs of mechanical, impact damage, dirt and electrical damage.

Visual Inspection Chart 

1. 3.
   
   If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.

1. 4.
   
   
   NOTE: Make sure to use the latest scan tool software release.

   If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).

1. 5.
   
   
   NOTE: The Vehicle Communication Module (VCM) LED prove-out confirms power and ground from the DLC are provided to the VCM.

   If the scan tool does not communicate with the VCM :

   • check the VCM connection to the vehicle.
   • check the scan tool connection to the VCM.
   • refer to Module Communications Network , No Power To The Scan Tool, to diagnose no power to the scan tool.

1. 6.
   
   If the scan tool does not communicate with the vehicle:
   • verify the ignition key is in the ON position.
   • verify the scan tool operation with a known good vehicle.
   • refer to Module Communications Network to diagnose no response from the DSM.

1. 7.
   
   Carry out the network test.
   • If the scan tool responds with no communication for one or more modules, refer to Module Communications Network .
   • If the network test passes, retrieve and record Continuous Memory Diagnostic Trouble Codes (CMDTCs).

1. 8.
   
   Clear the continuous DTCs and carry out the self-test diagnostics for the DSM.

1. 9.
   
   If the DTCs retrieved are related to the concern, go to the Driver Seat Module(DSM) DTC Chart. For all other DTCs, refer to Multifunction Electronic Modules .

1. 10.
   
   If no DTCs related to the concern are retrieved, GO to Symptom Chart - Exterior Mirrors  or GO to Symptom Chart - NVH  .