Symptom Chart: Headlamps

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to Service Information for information regarding Ford-specific diagnostic practices.

Condition	Possible Sources	Actions
A module does not respond to the scan tool	Fuse Wiring, terminals or connectors Module	REFER to Module Communications Network .
One or both low beams are inoperative	Fuse(s) Bulb Wiring, terminals or connectors Headlamp assembly BCM	GO to Pinpoint Test I .
One or both high beams are inoperative	Fuse Wiring, terminals or connectors Bulb LH steering column multifunction switch Headlamp assembly SCCM BCM	GO to Pinpoint Test J .
The low beams are on continuously	Wiring, terminals or connectors Headlamp switch SCCM BCM	GO to Pinpoint Test K .
The high beams are on continuously	Wiring, terminals or connectors LH steering column multifunction switch SCCM BCM	GO to Pinpoint Test L .
The flash-to-pass feature is inoperative	LH steering column multifunction switch SCCM BCM	GO to Pinpoint Test M .