Image Display - Vehicles Equipped With A 4.2 in (106.68 mm) Display

NOTE: The liftgate must remain closed for correct operation of the rear camera system.

The rear parking aid camera image is displayed by the FCDIM when the reverse gear is selected.

To determine the gear selector position and enable the camera display, the FCDIM monitors the transmission gear position message, received from the PCM. The camera is on any time it receives voltage (when the ignition is ON), but a video signal is only generated under certian conditions. When reverse gear is selected, the camera continuously generates a video signal. When any gear except reverse is selected, the camera turns the video signal off when the vehicle speed reaches 16 km/h (10 mph), and turns the video signal on when vehicle speed falls below 8 km/h (5 mph). The video signal is sent from the camera to the FCDIM on shielded twisted pair wires. If the camera is not configured properly, some features may be inoperative.

Features

The camera system has several features to assist the driver.

The following feature(s) can be turned on and off by the driver, accessed through the FCDIM :

Visual park aid alert - provides a visual highlight in the zone where an object has been detected by the rear parking aid system.
Manual zoom - assists the driver with connecting or towing a trailer by allowing the driver to manually zoom closer to an object behind the vehicle.
Video delay - keeps the rear camera image display active after the vehicle is shifted out of REVERSE, until the vehicle speed has exceeded 10 km/h (7 mph), or 10 seconds has elapsed since the vehicle was shifted out of REVERSE. The image will not be displayed if the vehicle is shifted into PARK.

The following feature(s) are always on and cannot be turned off:

Fixed guidelines - assists the driver with backing into a parking space or aligning the vehicle with an object.

To turn the visual park aid alert and manual zoom on and off, the driver-generated requests originate at the FCDIM. The requests are sent by the FCDIM to the BCM in the camera commands message. The BCM then sends the request to the camera via the LIN circuit. The requested features are then generated by the rear parking aid camera.

The video delay feature is controlled within the FCDIM.

The video camera retains the last known setting for the visual park aid alert when the ignition is turned off. The camera settings shown in the FCDIM menus when the ignition is off may not reflect the actual current camera settings. Within 3 seconds of the ignition being turned on, the FCDIM requests the last known settings from the rear camera, then changes the camera menu selections that are displayed to the settings that are retrieved from the rear camera. If the visual park aid alert settings are changed in the FCDIM when the ignition is off, the changes are not stored and the menus revert back to the last known settings that are stored in the camera after the ignition is turned on.