Pinpoint Test L : The Rear Video Is Inoperative: Notes
Refer to Audio System/Navigation - With Sync Without Touchscreen for schematic and connector information.
Normal Operation and Fault Conditions
Refer to Parking Aid - Video
BCM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B115E:01 | Camera Module: General Electrical Failure | Sets in continuous memory when the BCM detects an electrical fault in the rear camera. |
| B115E:08 | Camera Module: Bus Signal/Message Failure | Sets in continuous memory and on-demand when the BCM detects a LIN communication fault from the rear camera. |
| B1331:08 | Compass/Mirror Module: Bus Signal/Message Failure | On vehicles equipped with an interior auto-dimming mirror rear camera display, this DTC sets in continuous memory and on-demand when the BCM detects a LIN communication fault from the interior auto-dimming mirror. |
APIM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| C1001:01 | Vision System Camera: General Electrical Failure | A continuous DTC that sets in the APIM when no video signal is detected from the camera when reverse gear is selected. |
FCDIM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| C1001:01 | Vision System Camera: General Electrical Failure | A continuous DTC that sets in the FCDIM when no video signal is detected from the camera when reverse gear is selected. |
Possible Sources:
- Wiring, terminals or connectors
- Fuse
- Rear camera
- TR concern
- Video display concern
- LIN concern
Visual Inspection and Diagnostic Pre-Checks
- BCM fuse 34 (10A)
- Verify the liftgate is fully closed.
- If the camera is not configured after replacement, some video functions will be inoperative. Verify the camera configuration using a diagnostic scan tool.