Transport and Factory Mode Deactivation

Deactivation 

1. Place the ignition in the OFF position.
2. Verify the battery is fully charged. Refer to: Battery .
3. NOTE: On vehicles with Push-Button Start, place a programmed passive key in the PATS backup starting location.

   Place the ignition in the ON position.

4. NOTE: Steps 4 and 5 must be carried out within 10 seconds.

   Press and release the brake pedal 5 times.

5. Press and release the hazard switch 2 times (on, off).
6. NOTE: When exiting Factory mode, the IPC message center indicates NORMAL MODE when the procedure has been successfully completed.

   Place the ignition in the OFF position.