Wastegate Control Valve Solenoid: Installation

1. 1.
   
   Install the wastegate control valve solenoid, then install and tighten the wastegate control valve solenoid retainers. Torque: 89 lb.in (10 Nm)

Courtesy of FORD MOTOR CO.

1. 2.
   
   Connect the wastegate control valve solenoid hoses and the wastegate control valve solenoid electrical connector. Use the General Equipment: Hose Clamp Remover/Installer

Courtesy of FORD MOTOR CO.

1. 3.
   
   Install the underbody shield and the retainers.

Courtesy of FORD MOTOR COMPANY

1. 4.
   
   Install the Powertrain Control Module (PCM). Refer to: Powertrain Control Module (PCM) .