Pinpoint Test At : The Perimeter Alarm Chime Is Inoperative
- AT1 CHECK THE SEATBELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Monitor the seatbelt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.
Does the seatbelt warning chime operate for approximately 6 seconds?
Yes GO to AT2 No - AT2 CHECK THE OPERATION OF THE PERIMETER ALARM
- Arm the perimeter alarm using the remote key locking feature (key fob).
- Wait approximately 15 seconds for the system to arm.
- Open the driver door using the interior door handle.
Does the perimeter alarm sound after 12 seconds?
Yes GO to AT3 No REFER to: Perimeter Anti-Theft Alarm . - AT3 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to DTC Chart: IPC in this section. No GO to AT4 - AT4 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE BCM (BODY CONTROL MODULE) SELF-TEST
- Using a diagnostic scan tool, perform the BCM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Body Control Module (BCM) . No INSTALL a new BCM. REFER to: Body Control Module (BCM) .