B10D7:81, B10D7:94
Refer to Wiring Diagrams Cell 112 for schematic and connector information.
Normal Operation and Fault Conditions
When the ignition transitions to RUN or START, the BCM activates the PATS transceiver to read the key in the ignition lock cylinder. If the BCM does not receive a PATS key code or if the code is invalid, the PATS prevents the motor from entering the ready to drive mode and applying torque.
REFER to: Passive Anti-Theft System (PATS) - System Operation and Component Description .
BCM DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B10D7:81 | PATS Key: Invalid Serial Data Received | Sets when the BCM reads a partial or corrupt PATS key read. |
| B10D7:94 | PATS Key: Unexpected Operation | Sets when the BCM receives no PATS key read. This DTC sets if a non- PATS key is used to turn the ignition on. |
Possible Sources
- PATS key
- PATS transceiver
Visual Inspection and Diagnostic Pre-checks
- Inspect the PATS key for damage.
- Verify the correct key is used.