LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2017 >> C-Max Hybrid Titanium >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Parking Aid System >> Removal And Installation >> Parking Aid Camera >> Removal

Parking Aid Camera: Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. Remove the liftgate trim panel. Refer to: Liftgate Trim Panel .
  2. Remove the nuts, release the clips and push the wiring harness body plug through the liftgate.
    GFD224137Courtesy of FORD MOTOR COMPANY
  3. Remove the liftgate trim panel.
    GFD224138Courtesy of FORD MOTOR COMPANY
  4. Remove the rear parking aid camera.

    1. Disconnect the rear parking aid camera electrical connector.
    2. Release the tabs and position the rear parking aid camera outer bracket down.
    3. Position the rear parking aid camera upper bracket up.
    4. Remove the rear parking aid camera from the bracket.

GFD224139Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals