Network Message Chart
Module Network Input Messages - IPC
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| Active park assist status | BCM | Input used to identify the status of the active park assist button position used to activate the active park assist message displays. |
| Ambient air temperature data | PCM | Input used to control the outside air temperature display and for the temperature related plug vehicle in to charge message displays. |
| Battery charger service required | SOBDM | Input used to display the powertrain malfunction (wrench) indicator. |
| Battery service required | BECM | Input used for the high voltage battery faults input to display the powertrain malfunction (wrench) indicator. |
| Battery state of charge data | SOBDMC | Input used to control the electric vehicle (EV) RTT indicator. |
| Battery warning indicator request | BECM | Input used to display the hazard warning message and the hazard RTT warning indicator. |
| BLIS on | SODL | Input used to control the BLIS off RTT indicator. |
| Brake fluid level low | BCM | Brake fluid level status input used to control the low brake fluid level warning message. |
| Brake pedal applied | BCM | Input used to control the PRNDL not in park warning message. |
| Brake warning indicator request | ABS module | ABS input used to control the check brake system warning message. |
| Charge cord connection status | SOBDMC | Input used to control the charge cord connected RTT indiator (PHEV). |
| Check fuel fill inlet message request | PCM | Input used to display the check fuel fill inlet message. |
| Check plug to start display request | SOBDMC | Input used to control the charge cord connected RTT indiator and the drive prevention override message center warning display (PHEV). |
| Compass direction (touchscreen audio) | APIM | Input used to display the compass. |
| Cross traffic alert - left | SODL | Input used to display the CTA fault messages. |
| Cross traffic alert - right | SODR | Input used to display the CTA fault messages. |
| Cruise control set speed | PCM | Input used to control the displayed set speed in the cruise control RTT indiator. |
| Cruise control status | PCM | Input used to control the cruise control RTT indiator. |
| Door status | BCM | Input used to control the door ajar and liftgate ajar warning messages, the door/liftgate ajar RTT warning indicator, the engine off ready to drive messages, the Intelligent Access (IA) message display and the shift to park message. |
| Econometer | SOBDMC | Input used to control the ECO mode RTT indicator. |
| Energy coaching data | SOBDMC | Input used for the energy coaching display. |
| Engine coolant temperature data | PCM | Input used to display the engine over-temperature warning message. |
| Engine on oil maintenance message display | SOBDMC | Input used to display the engine on oil maintenance message. |
| Engine oil change minder | PCM | Input used to display the change oil message. |
| Engine overheat indication request | PCM | Input used for the failsafe display of the engine over-temperature warning message. |
| Engine rpm data | PCM | Input used to display the low oil pressure RTT indiator. |
| Engine service required | PCM | Input used for the engine faults (electronic throttle control) input for the powertrain malfunction (wrench) RTT indiator. |
| EPAS driver information display | PSCM | Input used to control the service power steering warning message. |
| Fuel maintenance mode display | SOBDMC | Input used to control the fuel maintenance message. |
| Gear lever position | PCM | Input used to display the engine off ready to drive message. |
| GPS data (without touchscreen audio) | GPSM | Input used to display the compass. |
| Hybrid mode message request | SOBDMC | Input used for the electric vehicle (EV) manage display. |
| Hybrid mode status display | SOBDMC | Input used for the electric vehicle (EV) manage display. |
| Ignition status | BCM | Ignition RUN, START and ACC states required for the IPC operating modes and fault reporting. Input used to display the PRNDL not in park warning message. |
| Key warning indication data | BCM | Input used to display the Intelligent Access (IA) no key detected, place key in backup slot, accessory power active and press brake to start message center warning displays. |
| Odometer count | PCM | Input used to display the odometer. |
| Oil pressure warning | PCM | Input used for the low oil pressure RTT warning indicator. |
| Park brake warning | BCM | Parking brake position switch input used to control the parking brake applied warning message. |
| Passive key warning | RFA | Input used to control the Intelligent Access (IA) key not inside vehicle message. |
| Parking aid fault message | PAM | Input used to display the parking aid system fault message. |
| Parking aid status | PAM | Input used to display the status of the parking aid system messages. |
| Perimeter alarm chime request | BCM | Input used to display the perimeter alarm active warning message. |
| Power system status | BCM | Input used for the charging system message center displays. |
| Powertrain ready status | SOBDMC | Input used to control the ready to drive message center display. |
| Press brake to start message request | BCM | Input used to display the press brake to start message. |
| Ready to drive indication request | SOBDMC | Input used to display the ready to drive message, the budget set ready messages and the ready to drive RTT indiator. |
| Refuel system status display | PCM | Input used to control the fuel door open delay message. |
| RKE key in trunk | RFA | Input used to control the Intelligent Access (IA) key inside luggage compartment warning message. |
| Stability-traction control indicator request | ABS module | Input used to display the service AdvanceTrac ® message. |
| Steering column failure | BCM | Input used to display the Intelligent Access (IA) steering column lock message. |
| Tire mobility kit message request | BCM | Input used to control the tire mobility kit status message. |
| TPMS data | BCM | Input used to display the TPMS tire training messages. |
| Transmission gear display | PCM | Used to control the PRNDL not in park warning message. |
| Transmission service required | SOBDMC | Input used for the transmission faults input to display the powertrain malfunction (wrench) RTT indiator. |
| Transmission shift mode | PCM | Input used to control the grade assist RTT warning indicator. |
| Transmission warning indicator request | SOBDMC | Input used to display hazard warning message and RTT warning indicator. |
| Vehicle mode | BCM | Input used to display the factory mode or transport mode messages. |
| Vehicle speed | PCM | Input used to control the PRNDL not in park warning message. |