Cooler Bypass Valve - 2.5L Duratec (125kW/170PS), Liquefied Petroleum Gas (LPG): Removal
- 1.
Remove the battery tray. Refer to: Battery Tray - 2.5L Duratec (125kW/170PS) .
- 2.
- Disconnect the quick release couplings from the air cleaner outlet pipe. Refer to: Quick Release Coupling .
- Loosen the clamp and remove the air cleaner outlet pipe.
- 3.NOTE: Use suitable paper to absorb any escaping fluid.
- 1.
Remove the transmission mounted transmission fluid cooler outlet tube bolt. Loosen the nut and remove the transmission mounted transmission fluid cooler outlet tube.
- 2.
Remove the transmission mounted transmission fluid cooler inlet tube bolt. Loosen the nut and remove the transmission mounted transmission fluid cooler inlet tube.
- 1.
- 4.NOTE: Make sure that no component falls off during removal.
Remove the band seals and backing rings from the transmission fluid cooler.
- 5.
- 1.
Loosen the nut and remove the transmission mounted transmission fluid cooler outlet tube.
- 2.
Loosen the nut and remove the transmission mounted transmission fluid cooler inlet tube.
- 1.
- 6.
- Remove the bolt and the transmission fluid thermal bypass valve.
- Remove the bolt and the transmission fluid thermal bypass valve mounting bracket.