Transport and Factory Mode Deactivation
Deactivation
WARNING:
Before beginning any service procedure in this article, refer to Safety Warnings in General Information. Failure to follow this instruction may result in serious personal injury.
- 1.
Refer to: Health and Safety Precautions
.
- 2.
Place the ignition in the OFF position.
- 3.
Verify the battery is fully charged. Refer to: Battery
.
- 4.
Place the ignition in the ON position.
- 5.
NOTE:
Steps 5 and 6 must be carried out within 10 seconds.
Press and release the brake pedal 5 times.
- 6.
Press and release the hazard switch 2 times (on, off).
- 7.
NOTE:
When exiting Factory mode, the IPC message center will indicate NORMAL MODE when the procedure has been successfully completed.
Place the ignition in the OFF position.