LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2016 >> Mustang V6, 2D Convertible, Standard Trans >> Labor Times >> Other Variant >> Brakes >> Mechanical - Hydraulic >> Brake Shoes &/Or Pads >> Remove & Replace

Brake Shoes &/Or Pads: Remove & Replace

WARNING: This page is about the Mustang EcoBoost, Automatic Trans, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies ToNoteStandard HoursWarranty HoursSkill Level
All1.8B
Front or Rear1.0B
Combination Procedure: BRAKE HOSE: Replace:
Each AdditionalIncludes: Bleed Brakes.0.2B
OneIncludes: Bleed Brakes.0.8B
Combination Procedure: CALIPER: Replace:
OneIncludes: Bleed Brakes.0.7B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
0.5B
Combination Procedure: DISC ROTOR: Remove and Install for Refinishing:
NOTE: This operation does not apply to drive axles. If on vehicle refinishing is not possible use appropriate repair operation.
Front,Each0.4B
Rear,Each0.4B
Combination Procedure: DISC ROTOR: Replace:
Front,Each0.1B
Rear,w/o Parking Brake Shoes,Each0.1B
Rear,w/Parking Brake Shoes,Both0.6B
Rear,w/Parking Brake Shoes,One Side0.3B
Combination Procedure: PARKING BRAKE SHOE & LINING: Remove & Replace:
Brake Shoes,Both0.6B
Brake Shoes,One Side0.3B
Combination Procedure: WHEEL BEARING: Replace:
FrontRefer to Wheel Hub - R&R.B
RearRefer to Wheel Hub - R&R.B