Parking Brake Switch: Removal
NOTE:
Removal steps in this procedure may contain installation details.
- 1.
Open the floor console stowage bin lid.
- 2.
On both sides. Detach the clips and remove the floor console upper side finish panels.
- 3.
Detach the clips and remove the transmission selector lever finish panel.
- 4.
Detach the clips and remove the upper floor console finish panel.
- 5.
Detach the clips and position the floor console upper trim panel, cup holder and switch assembly to access the EPB switch.
- 6.
Disconnect the electrical connector, remove the 3 screws and the EPB switch.