Brake Fluid Reservoir: Removal
NOTE:
If the brake fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.
NOTE:
Removal steps in this procedure may contain installation details.
- 1.
Remove the brake master cylinder. Refer to: Brake Master Cylinder .
- 2.
Remove the pin and the brake fluid reservoir.Torque
: 49 lb.in (5.5 Nm)
- 3.NOTE: Install new brake fluid reservoir seals. Lubricate the seals with clean, specified brake fluid.
Remove and discard the brake fluid reservoir seals.
Material
: Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake Fluid / PM-20 (WSS-M6C65-A2)