Stability-Traction Control Disabled Indicator (Sliding Car OFF Icon)

The stability-traction control is configured on/off through the message center. When the driver enables or disables the stability-traction control system, the ABS module sends the stability-traction control disabled indicator request message to the GWM over the High Speed Controller Area Network 2 (HS2-CAN). The GWM sends the stability-traction control disabled indicator request message to the IPC over the High Speed Controller Area Network 3 (HS3-CAN) to illuminate or turn off the stability-traction control disabled indicator (sliding car OFF icon) based upon the system state.

Refer to ABS/Brake/Stability-Traction Control System Indication  description for information on the conditions when the stability-traction control disabled indicator (sliding car OFF icon) is turned on.

When a MyKey® administrator has set the AdvanceTrac® feature to always on and a MyKey® programmed key is in use, the stability-traction control system cannot be disabled. The menu selection in the message center used to disable the stability-traction control system does not display when a MyKey® is in use, but remains active for the MyKey® administrator to select the AdvanceTrac® always on feature off. The stability-traction control indicator still functions normally to indicate a stability-traction control system fault and a stability-traction control active event.

Refer to ABS/Brake/Stability-Traction Control System Indication  description for information on the conditions when the stability-traction control indicator (sliding car icon) is turned on.