LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2016 >> Fusion Titanium, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Warning Systems >> Collision Warning System And Collision Avoidance System (Except Hybrid) >> Diagnosis And Testing >> Collision Warning and Collision Avoidance System >> Pinpoint Tests >> Pinpoint Test F : U210A:16 Or U210A:17 >> Pinpoint Test F : U210A:16 Or U210A:17

Pinpoint Test F : U210A:16 Or U210A:17

  1. F1 CHECK FOR HUD (HEAD UP DISPLAY) MODULE DIAGNOSTIC TROUBLE CODES (DTCS)

    • Engine OFF.
    • Ignition ON.
    • Using a diagnostic scan tool, clear the HUD module Continuous Memory Diagnostic Trouble Codes (CMDTCs).
    • Retrieve Continuous Memory Diagnostic Trouble Codes (CMDTCs).

    Is DTC U210A:16 or U210A:17 recorded? 

    Yes  GO to  F2
    No  The system is operating normally at this time. The DTC may have been set previously due to an internal intermittent fault with the temperature sensor circuit.

  2. F2 CHECK FOR CORRECT HUD (HEAD UP DISPLAY) OPERATION

    • Ignition OFF.
    • Disconnect and inspect all HUD module connectors.
    • Repair:
      • corrosion (install new connector or terminals - clean module pins)
      • damaged or bent pins - install new terminals/pins
      • pushed-out pins - install new pins as necessary
    • Reconnect the HUD module connectors. Make sure they seat and latch correctly.
    • Operate the system and determine if the concern is still present.

    Is the concern still present? 

    Yes  CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new HUD module. REFER to: Head Up Display (HUD) Module .
    No  The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.
scientia non olet · About LEMON Manuals