Supplemental Restraint System (SRS) Depowering and Repowering

Depower 

1. 1.
   
   
   WARNING: Before beginning any service procedure, refer to Safety Warnings in General Information. Failure to follow this instruction may result in serious personal injury.
   NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

   Refer to: Health and Safety Precautions .

1. 2.
   
   Turn the ignition OFF.

1. 3.
   
   At the BCM, located under the instrument panel, to the left of the steering column, remove the BCM fuse 35 (5A). Refer to OEM Fuse And Relay Location (Hybrid/Energi) for schematic and connector information.

1. 4.
   
   Turn the ignition ON and monitor the airbag warning indicator for at least 30 seconds. The airbag warning indicator remains lit continuously (no flashing) if the correct RCM fuse is removed. If the airbag warning indicator is not lit continuously, remove the correct RCM fuse before proceding.

1. 5.
   
   Turn the ignition OFF.

1. 6.
   
   Disconnect the battery. Refer to: Battery Disconnect and Connect .

1. 7.
   
   Wait at least one minute before continuing vehicle service.

Repower 

1. 1.
   
   
   WARNING: Before beginning any service procedure, refer to Safety Warnings in General Information. Failure to follow this instruction may result in serious personal injury.
   NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

   Refer to: Health and Safety Precautions .

1. 2.
   
   Install BCM fuse 35 (5A).

1. 3.
   
   Connect the battery. Refer to: Battery Disconnect and Connect .

1. 4.
   
   Sit in the driver seat in an upright position. Make sure no objects are between you and the driver airbag, driver lower airbag, side airbag or side air curtain.

   Dimension: 10.0 in (25.4 cm)

1. 5.
   
   Move the driver seat to the rearmost position.

1. 6.
   
   Turn the ignition from OFF to ON.

1. 7.
   
   
   • Prove out the SRS as follows: Turn the ignition from ON to OFF. Wait 10 seconds, then turn the ignition back to ON and monitor the airbag warning indicator with the airbag modules installed. The airbag warning indicator illuminates continuously for approximately 6 seconds and then turns off. If a SRS fault is present, the airbag warning indicator either fails to light, remains lit continuously or flashes.
   • The flashing may not occur until approximately 30 seconds after the ignition has been turned from OFF to ON. This is the time required for the RCM to complete the testing of the SRS. If the airbag warning indicator is inoperative and a SRS fault exists, a chime sounds in a pattern of 5 sets of 5 beeps. If this occurs, diagnose and repair the airbag warning indicator and any SRS faults.

1. 8.
   
   Using a scan tool, clear all Continuous Memory Diagnostic Trouble Codes (CMDTCs) from all modules.