DDM DTC Chart
WARNING: This page is about a different car, the 2015 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods
| DTC | Description | Action |
|---|---|---|
| B1087:83 | LIN Bus "A": Value Of Signal Protection Calculation Incorrect | GO to Pinpoint Test AB |
| B1087:87 | LIN Bus "A": Missing Message | GO to Pinpoint Test AB |
| B1088:83 | LIN Bus "B": Value of Signal Protection Calculation Incorrect | REFER to: Glass, Frames and Mechanisms |
| B1088:87 | LIN Bus "B": Missing Message | REFER to: Glass, Frames and Mechanisms |
| B108F:23 | Cabin Lock/Unlock Switch: Signal Stuck Low | GO to Pinpoint Test K |
| B1163:11 | Left Mirror Heater Output: Circuit Short To Ground | REFER to: Rear View Mirrors |
| B1163:15 | Left Mirror Heater Output: Circuit Short To Battery or Open | REFER to: Rear View Mirrors |
| B1165:11 | Left Front Puddle Lamp Output: Circuit Short To Ground | REFER to: Interior Lighting |
| B1165:15 | Left Front Puddle Lamp Output: Circuit Short To Battery or Open | REFER to: Interior Lighting |
| B117C:07 | Rear Power Window Up: Mechanical Failure | REFER to: Glass, Frames and Mechanisms |
| B117C:16 | Rear Power Window Up: Circuit Voltage Below Threshold | REFER to: Glass, Frames and Mechanisms |
| B117C:4B | Rear Power Window Up: Over Temperature | REFER to: Glass, Frames and Mechanisms |
| B117C:92 | Rear Power Window Up: Performance or Incorrect Operation | REFER to: Glass, Frames and Mechanisms |
| B117E:07 | Front Power Window Up: Mechanical Failure | REFER to: Glass, Frames and Mechanisms |
| B117E:92 | Front Power Window Up: Performance or Incorrect Operation | REFER to: Glass, Frames and Mechanisms |
| B1189:29 | Front Window Position Sensor: Signal Invalid | REFER to: Glass, Frames and Mechanisms |
| B118A:29 | Rear Window Position Sensor: Signal Invalid | REFER to: Glass, Frames and Mechanisms |
| B118C:11 | Left Blind Spot Warning Indicator: Circuit Short To Ground | REFER to: Blind Spot Information System |
| B118C:15 | Left Blind Spot Warning Indicator: Circuit Short To Battery or Open | REFER to: Blind Spot Information System |
| B11DA:23 | Driver Door Key Cylinder Switch: Signal Stuck Low | REFER to: Perimeter Anti-Theft Alarm |
| B11F6:11 | Driver Folding Mirror Motor: Circuit Short To Ground | REFER to: Rear View Mirrors |
| B11F6:11 | Driver Folding Mirror Motor: Circuit Short To Battery or Open | REFER to: Rear View Mirrors |
| B12C5:71 | Front Window Lifter Motor Up Relay: Actuator Stuck | REFER to: Glass, Frames and Mechanisms |
| B12C6:71 | Rear Window Lifter Motor Up Relay: Actuator Stuck | REFER to: Glass, Frames and Mechanisms |
| B12C7:71 | Front Window Lifter Motor Down Relay: Actuator Stuck | REFER to: Glass, Frames and Mechanisms |
| B12C8:71 | Rear Window Lifter Motor Down Relay: Actuator Stuck | REFER to: Glass, Frames and Mechanisms |
| B12E9:24 | Rear Window Local Up/Down Switch: Signal Stuck High | REFER to: Glass, Frames and Mechanisms |
| B12FF:11 | Rear Door Switch Illumination: Circuit Short To Ground | REFER to: Instrument Panel and Interior Switches Illumination |
| B12FF:15 | Rear Door Switch Illumination: Circuit Short To Battery Or Open | REFER to: Instrument Panel and Interior Switches Illumination |
| B13F0:4B | Left Rear Power Window Motor: Over Temperature | REFER to: Glass, Frames and Mechanisms |
| B13F1:4B | Driver Power Window Motor: Over Temperature | REFER to: Glass, Frames and Mechanisms |
| B1C03:23 | Memory #1 Switch: Signal Stuck Low | REFER to: Front Seats |
| B1C04:23 | Memory #2 Switch: Signal Stuck Low | REFER to: Front Seats |
| B1C05:23 | Memory #3 Switch: Signal Stuck Low | REFER to: Front Seats |
| B1C09:11 | Driver Left/Right Mirror Motor: Circuit Short To Ground | REFER to: Rear View Mirrors |
| B1C09:15 | Driver Left/Right Mirror Motor: Circuit Short To Battery or Open | REFER to: Rear View Mirrors |
| B1C10:11 | Driver Up/Down Mirror Motor: Circuit Short To Ground | REFER to: Rear View Mirrors |
| B1C10:15 | Driver Up/Down Mirror Motor: Circuit Short To Battery or Open | REFER to: Rear View Mirrors |
| B1C13:11 | Driver Up/Down Mirror Motor Feedback: Circuit Short To Ground | REFER to: Rear View Mirrors |
| B1C13:15 | Driver Up/Down Mirror Motor Feedback: Circuit Short To Battery or Open | REFER to: Rear View Mirrors |
| B1C14:11 | Driver Left/Right Mirror Motor Feedback: Circuit Short To Ground | REFER to: Rear View Mirrors |
| B1C14:15 | Driver Left/Right Mirror Motor Feedback: Circuit Short To Battery or Open | REFER to: Rear View Mirrors |
| B1D06:11 | Left Turn Indicator: Circuit Short To Ground | REFER to: Turn Signal and Hazard Lamps |
| C1B14:11 | Sensor Supply Voltage A: Circuit Short To Ground | REFER to: Glass, Frames and Mechanisms |
| C1B14:15 | Sensor Supply Voltage A: Circuit Short To Battery or Open | REFER to: Glass, Frames and Mechanisms |
| C1B15:11 | Sensor Supply Voltage B: Circuit Short To Ground | REFER to: Rear View Mirrors |
| C1B15:15 | Sensor Supply Voltage B: Circuit Short To Battery or Open | REFER to: Rear View Mirrors |
| U0010:00 | Medium Speed CAN Communication Bus: No Sub Type Information | The module was unable to communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this DTC). VERIFY the continuity of the connectors and wiring. Refer to Wiring Diagram MODULE COMMUNICATIONS NETWORK for schematic and connector information. |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test AC |
| U0208:00 | Lost Communication With "Seat Control Module A": No Sub Type Information | GO to Pinpoint Test AD |
| U0232:00 | Lost Communication With Side Obstacle Detection Control Module - Left: No Sub Type Information | GO to Pinpoint Test AE |
| U0300:00 | Internal Control Module Software Incompatibility: No Sub Type Information | CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the DTC is retrieved again, INSTALL a new DDM. REFER to: Driver Door Module (DDM) |
| U0300:4A | Internal Control Module Software Incompatibility: Incorrect Component Installed | PERFORM the PMI using as-built data. CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the DTC returns, INSTALL a new DDM. REFER to: Driver Door Module (DDM) |
| U0422:00 | Invalid Data Received From Body Control Module: No Sub Type Information | RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) from the BCM. REFER to: Body Control Module (BCM) |
| U0509:00 | Invalid Data Received From "Seat Control Module A": No Sub Type Information | RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) from the DSM. REFER to: Front Seats |
| U0533:00 | Invalid Data Received From Side Obstacle Detection Control Module-Left: No Sub Type Information | RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) from the SODL. REFER to: Blind Spot Information System |
| U2010:00 | Switch Illumination: No Sub Type Information | REFER to: Instrument Panel and Interior Switches Illumination |
| U2013:24 | Switch Pack: Signal Stuck High | REFER to: Glass, Frames and Mechanisms |
| U2014:00 | Control Module Hardware: No Sub Type Information | INSTALL a new DDM. REFER to: Driver Door Module (DDM) |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | PERFORM the PMI using as-built data. CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the DTC returns, INSTALL a new DDM. REFER to: Driver Door Module (DDM) |
| U3000:04 | Control Module: System Internal Failure | INSTALL a new DDM. REFER to: Driver Door Module (DDM) |