LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2016 >> Fusion Titanium Hybrid >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Panel System - Body Closures (Hybrid/ENERGI) >> Removal And Installation >> Luggage Compartment Lid >> Removal

Luggage Compartment Lid: Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. 1.

    Open the luggage compartment lid.
GFD72079Courtesy of FORD MOTOR COMPANY

  1. 2.

    1. 1.

      Position aside the luggage compartment lid pull handle cover.

    1. 2.

      Remove the trim cover.

    1. 3.

      Remove the screws and the luggage compartment pull handle.
GFD72081Courtesy of FORD MOTOR COMPANY

  1. 3.

    Insert a flat blade screwdriver in the latch housing slot and slowly pry down to disengage the tabs on the latch and remove the trim cover.Use the General Equipment: Flat-Bladed Screwdriver
GFD119501Courtesy of FORD MOTOR COMPANY

  1. 4.

    1. 1.

      Remove the pin-type retainers.

    1. 2.

      Remove the trim panel, passing the emergency release handle through the trim panel opening.
GFD72082Courtesy of FORD MOTOR COMPANY

  1. 5.

    Disconnect the electrical connector, detach the wiring harness retainers and position the wiring harness aside.
GFD72083Courtesy of FORD MOTOR COMPANY

  1. 6.

    Index-mark the hinge location to aid in luggage compartment lid installation.
GFD72084Courtesy of FORD MOTOR COMPANY

  1. 7.

    Remove the bolts and the luggage compartment lid.

    Torque: 89 lb.in (10 Nm)

GFD72085Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals