Steering Column Control Module (SCCM): Removal
NOTE:
Removal steps in this procedure may contain installation details.
- 1.WARNING: Before beginning any service procedure, refer to Safety Warnings in General Information. Failure to follow this instruction may result in serious personal injury.
Follow the health and safety precautions. Refer to: Health and Safety Precautions .
- 2.
If installing a new SCCM, connect the diagnostic scan tool and upload the module configuration information from the SCCM.
- 3.
Remove the steering wheel. Refer to: Steering Wheel .
- 4.
Remove the steering column shrouds. Refer to: Steering Column Shrouds .
- 5.
- Detach the retainer and disconnect the electrical connectors.
- Remove the SCCM screws.
Torque: 27 lb.in (3 Nm)