Timing Drive Components: Installation
NOTE:
If the timing chain plunger and ratchet assembly are not pinned in the compressed position, follow the next 4 steps.
- 4.NOTE: Do not compress the ratchet assembly. This will damage the ratchet assembly.
Using the edge of a vise, compress the timing chain tensioner plunger.
- 7.
Install a holding pin into the hole in the tensioner housing to hold the ratchet assembly and the plunger in during installation.
- 9.NOTE: The Camshaft Alignment Plate is for camshaft alignment only. Using this tool to prevent engine rotation can result in engine damage.NOTE: Use the flats on the camshafts to prevent camshaft rotation.
Torque:
Stage 1: 30 lb.ft (40 Nm)
Stage 2: 60 °
- 10.
Refer to: Engine Front Cover - Hybrid Electric Vehicle (HEV) .