LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2016 >> Focus Electric >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 143 (Parking Aid System - Vehicles With: Rear Parking Aid (Except Electric Vehicle)) >> Removal And Installation >> Rear Parking Aid Sensor >> Removal

Rear Parking Aid Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.
NOTE: This procedure can be used for all locations of the component.

  1. 1.

    Remove the rear bumper cover. REFER to: Rear Bumper Cover - 4-Door REFER to: Rear Bumper Cover - 5-Door

  1. 2.

    Remove the parking aid sensor.
    • Disconnect the parking aid sensor electrical connector.
    • Release the tabs.
    • Remove the parking aid sensor from the bracket.
GFD63463Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals