Removal And Installation: Thermostat: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
- 1.
Drain the cooling system. Refer to: Cooling System Draining, Vacuum Filling and Bleeding .
- 2.
Remove the generator. Refer to: Generator - 1.6L EcoBoost (132kW/180PS) - Sigma .
- 3.
Disconnect the coolant shutoff solenoid valve electrical connector, detach the retainer and position the wiring harness aside.
- 4.
- 1.
Release the clip.
- 2.
Disconnect the coolant outlet hose.
- Release the clamp and disconnect the radiator hose.
- 1.
- 6.
Release the clamp and disconnect coolant bypass hose. Use the General Equipment: Hose Clamp Remover/Installer