Coolant Shutoff Solenoid Valve: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
- 1.
Drain the cooling system. Refer to: Cooling System Draining, Vacuum Filling and Bleeding .
- 3.
- 1.
Disconnect the resonator tube.
- 2.
Release the clamp.
- 3.
Detach the grommet.
- 4.
Loosen the clamp and remove the resonator assembly.
- 5.
Loosen the clamp.
- 6.
Position aside the CAC outlet pipe.
- 1.
- 4.
Refer to: Jacking and Lifting - Overview .
- 6.
- 1.
Remove the bolt.Torque: 133 lb.in (15 Nm)
- Disconnect the electrical connector and the vent tube.
- Loosen the clamp and remove the CAC inlet pipe.
- 1.
- 8.
Disconnect the coolant shutoff solenoid valve electrical connector, detach the retainer and position the wiring harness aside.
- 9.
- 1.
Release the clip.
- 2.
Disconnect the coolant hose.
- 3.
Remove the bolts and the coolant shutoff solenoid valve.Torque: 89 lb.in (10 Nm)
- 1.