Halfshaft Seal RH: Removal
WARNING: This page is about a different variant/trim than selected.
- 1.
Remove the wheel and tire. Refer to: Wheel and Tire .
- 3.NOTE: Do not use a prying device or separator fork between the ball joint and the wheel knuckle. Damage to the ball joint or ball joint seal may result. Only use the pry bar by inserting it into the lower arm body opening.NOTE: Use care when releasing the lower arm and wheel knuckle into the resting position or damage to the ball joint seal may result.
Remove and discard the wheel knuckle bolt and the nut. Remove the lower control arm from the knuckle.
- 5.NOTE: Do not pull on the outer part of the halfshaft or the CV joint will separate. Always pull on the inner part of the halfshaft.
Remove and support the RH halfshaft from the transmission.