Inspection and Verification

WARNING: This page is about a different variant/trim than selected.

NOTE: If transmission noise is reported, check the fluid level first. Do not drive the vehicle if the fluid level is low or damage can occur.

Visual Inspection Chart

Mechanical
Oil leaks. Visibly damaged or worn components. Loose or missing nuts or bolts.

3.

If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.

4.

If the cause is not evident, verify the symptom and REFER to the Symptom Chart.

The following checks should be carried out before repairing or installing a new transmission.

The inspection and verification of manual transmission concerns can be considered in three main areas.