Removal And Installation: Radiator: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
- 1.
With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- 2.
Drain the cooling system. Refer to: Cooling System Draining, Vacuum Filling and Bleeding .
- 3.
Remove the cooling fan motor and shroud. Refer to: Cooling Fan Motor and Shroud .
- 4.
Disconnect the upper and lower radiator hoses. Use the General Equipment: Hose Clamp Remover/Installer
- 6.
Remove both headlamps. Refer to: Headlamp Assembly .
- 7.
Remove the front bumper cover. Refer to: Front Bumper Cover .
- 11.
- 1.
Position a safety stand under the front bumper. Use the General Equipment: Vehicle/Axle Stands
- 2.
Remove the bolts.Torque: 18 lb.ft (25 Nm)
- 1.
- 16.NOTE: Use caution not to over extend the lower radiator tabs.
Unclip the lower tabs and lift the radiator upward while pressing down on the A/C condenser.