Coolant Pump: Removal
WARNING: This page is about a different variant/trim than selected.
- 1.
With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- 2.
Drain the cooling system. Refer to: Cooling System Draining, Vacuum Filling and Bleeding .
- 3.
If equipped with FEAD shield.- Disconnect the vent tube.
- Loosen the clamps and remove the turbocharger inlet tube.
- 4.
- 1.
If equipped with FEAD shield. Remove the bolt and the support bracket. Loosen the clamp and disconnect the CAC tube.
- 1.
- 7.
Remove the accessory drive belt. Refer to: Accessory Drive Belt .