Pinpoint Test A : Slow To Fill
WARNING: This page is about a different variant/trim than selected.
- A1 CHECK COMPONENTS FOR SIGNS OF DAMAGE
- Visually inspect the following components for signs of damage:
- Fuel tank filler pipe
- Fuel tank filler pipe vent tube, if equipped
- EVAP system
- Fuel tank inlet check valve (part of the fuel tank)
- Fuel level vent valve (part of the fuel tank)
Was the cause of the concern found?
Yes REPAIR or INSTALL new components to correct the concern. No GO to A2 - Visually inspect the following components for signs of damage:
- A2 CHECK THE FUEL TANK FILLER PIPE ASSEMBLY FOR BLOCKAGE OR RESTRICTION
- Remove the fuel tank filler pipe assembly. Refer to: Fuel Tank Filler Pipe .
- Inspect the fuel tank filler pipe and fuel tank filler pipe vent tube (if equipped) for a blockage or restriction.
Is the fuel tank filler pipe or fuel tank filler pipe vent tube (if equipped) blocked or restricted?
Yes If possible, REPAIR the blockage or restriction. If the blockage or restriction cannot be repaired, INSTALL a new fuel tank filler pipe or fuel tank filler pipe vent tube. No GO to A3 - A3 CHECK THE FUEL TANK INLET CHECK VALVE
- Inspect the fuel tank inlet check valve for restriction or sticking.
Is the fuel tank filler pipe inlet check valve restricted or sticking?
Yes If possible, REPAIR the restriction. If the restriction cannot be repaired, INSTALL a new fuel tank. Refer to: Fuel Tank . No INSTALL a new fuel tank.