Starter Motor: Installation
WARNING: This page is about a different variant/trim than selected.
- 1.
- 1.
Install the starter motor, then install and tighten the starter motor retaining bolt.Torque: 26 lb.ft (35 Nm)
- 2.
Connect the battery positive cable at the starter motor, then install and tighten the battery positive cable retaining nut.Torque: 106 lb.in (12 Nm)
- 3.
Connect the starter motor control wire at the starter motor, then install and tighten the starter motor control wire retaining nut.Torque: 53 lb.in (6 Nm)
- 1.