Oil Cooler: Installation

WARNING: This page is about a different variant/trim than selected.

1.

Install the oil cooler and the bolt.
Torque: 41 lb.ft (55 Nm)

GFD138784

Courtesy of FORD MOTOR COMPANY

2.
- 1.
  
  Using the hose clamp installer, install the coolant hoses. Use the General Equipment: Hose Clamp Remover/Installer
- 2.
  
  Remove the hose locking pliers.

GFD138785

Courtesy of FORD MOTOR COMPANY

3.

NOTE: Lubricate the engine oil filter gasket with clean engine oil.

Install a new engine oil filter.

Torque: 128 lb.in (14.5 Nm)

GFD138786

Courtesy of FORD MOTOR COMPANY

4.

Inspect and adjust the coolant level in the degas bottle.
Material: Motorcraft ® Orange Concentrated Antifreeze/Coolant / VC-3-B (WSS-M97B44-D)

Material: Motorcraft ® Orange Prediluted Antifreeze/Coolant / VC-3DIL-B (WSS-M97B44-D2)

5.

Inspect and adjust the engine oil level.
Material: Motorcraft ® SAE 5W-20 Synthetic Blend Motor Oil / XO-5W20-QSP (WSS-M2C945-A)