Cylinder Head: Installation

WARNING: This page is about a different variant/trim than selected.

1.

Install the cylinder head gasket.

GFD138710

Courtesy of FORD MOTOR COMPANY

2.

Install the cylinder head and the bolts finger-tight.

GFD138711

Courtesy of FORD MOTOR COMPANY

3.

NOTE: Make sure that new bolts are installed.

NOTE: Only tighten the bolts finger tight at this stage.

Tighten the cylinder head bolts in sequence shown in 6 stages.

Torque:

Stage 1: 89 lb.in (10 Nm)

Stage 2: 30 lb.ft (40 Nm)

Stage 3: Loosen: 45 °

Stage 4: 22 lb.ft (30 Nm)

Stage 5: 90 °

Stage 6: 90 °

Fig 1: Cylinder Head Tightening Sequence

GFD138712

Courtesy of FORD MOTOR COMPANY

4.

NOTE: Install the components in their original position.

Lubricate and install the valve tappets.

Material: Motorcraft ® SAE 5W-20 Synthetic Blend Motor Oil / XO-5W20-QSP (WSS-M2C945-A)

GFD138713

Courtesy of FORD MOTOR COMPANY

5.

Install the camshafts. Refer to: Camshafts .

6.

Position the thermostat housing and install the bolts.
Torque: 89 lb.in (10 Nm)

GFD138706

Courtesy of FORD MOTOR COMPANY

7.

Position the coolant hose and connect the coupling.

GFD138705

Courtesy of FORD MOTOR COMPANY

8.

Position the vacuum pump assembly and install the bolts.
Torque: 89 lb.in (10 Nm)

GFD138663

Courtesy of FORD MOTOR COMPANY

9.

Attach the vacuum harness retainer.

GFD138704

Courtesy of FORD MOTOR COMPANY

10.

Install the turbocharger. Refer to: Turbocharger .

11.

Fill the cooling system. Refer to: Cooling System Draining, Vacuum Filling And Bleeding .