Crankshaft Rear Seal: Installation

WARNING: This page is about a different variant/trim than selected.

1.

NOTE: Make sure that the mating faces are clean and free of foreign material.

NOTE: New crankshaft rear seal carriers are supplied with an alignment sleeve which must be removed after installation.

Install the rear crankshaft seal and the bolts in sequence shown.

Torque: 89 lb.in (10 Nm)

Fig 1: Crankshaft Rear Seal Tightening Sequence

GFD138703

Courtesy of FORD MOTOR COMPANY

2.

Install the flywheel. Refer to: Flywheel .

3.

Install the oil pan. Refer to: Oil Pan .