Coolant Pump: Installation

WARNING: This page is about a different variant/trim than selected.

1.

Install a new coolant pump gasket and O-ring seal.

GFD39914

Courtesy of FORD MOTOR COMPANY

2.

Install the coolant pump and the bolts.
Torque:

Stage 1: 89 lb.in (10 Nm)

Stage 2: 45 °

GFD40304

Courtesy of FORD MOTOR COMPANY

3.

Position the coolant pump pulley and install the bolts finger tight.

GFD40795

Courtesy of FORD MOTOR COMPANY

4.

Install the thermostat housing. Refer to: Thermostat Housing .

5.

Remove the plastic from the A/C compressor belt.

6.

Install the accessory drive belt. Refer to: Accessory Drive Belt .

7.

Tighten the coolant pump pulley bolts.
Torque: 18 lb.ft (24 Nm)

GFD40794

Courtesy of FORD MOTOR COMPANY

8.

Position the degas bottle back and tighten the bolts.
Torque: 62 lb.in (7 Nm)

GFD40796

Courtesy of FORD MOTOR COMPANY

9.

Install the air cleaner outlet pipe. Refer to: Air Cleaner Outlet Pipe .

10.

Fill and bleed the cooling system. Refer to: Cooling System Draining, Vacuum Filling and Bleeding .