Variable Camshaft Timing (VCT) Oil Control Solenoid: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
RH (right-hand) Variable Camshaft Timing (VCT) Oil Control Solenoids
- 1.
Remove the RH valve cover. Refer to: Valve Cover RH .
- 2.
Remove the bolts and the RH VCT oil control solenoids.Torque:
Stage 1: 71 lb.in (8 Nm)
Stage 2: 20 °
LH (left-hand) Variable Camshaft Timing (VCT) Oil Control Solenoids
- 3.
Remove the LH valve cover. Refer to: Valve Cover LH .
- 4.
Remove the bolts and the LH VCT oil control solenoids.Torque:
Stage 1: 71 lb.in (8 Nm)
Stage 2: 20 °