LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2016 >> F-150 Limited, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Electronic Engine Controls System - 5.0L 32V Ti-VCT) >> Removal And Installation >> Oil Pressure Control Solenoid >> Removal

Oil Pressure Control Solenoid: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.

  1. 1.

    Remove the LH fender splash shield. Refer to: Fender Splash Shield .

  1. 2.

    Disconnect the electrical connector, remove the bolt and the oil pressure control solenoid.

    Torque: 97 lb.in (11 Nm)

GFD41278Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals